Monitor Audio Vector Manuel de service télécharger pdf (Page 93)

Adjustment Procedures: Analog Section

WFM90D and WFM91D Service Manual

5-9

23. Select CAL MENU, and then select SAVE.

24. Select X1 GAIN from the Operating menu, and INT REF from the

Configuration menu.

Vector Quadrature Phase

Perform these steps to adjust the vector quadrature phase:

1. Replace the signal on the VIDEO IN connector with a 75% color bar signal

from the television signal generator using a 75 Ω in-line termination.

2. Select VECTOR display mode.

3. WFM91D ONLY — Select ALT ON from the Configuration menu.

4. Select QUAD PH from the Calibration menu, select CAL, and then select

RY OFFSET.

5. Adjust the arrow buttons for the best center dot overlay.

6. Select QUAD PH.

7. Adjust the arrow buttons for the best circle overlay.

8. Select CAL MENU, and then select SAVE.

9. WFM91D ONLY — Select ALT OFF from the Configuration menu.

Vector Gain and X5 Gain Phase

Perform these steps to adjust the vector gain and X5 gain phase:

1. WFM90D ONLY — Verify that the television signal generator has setup

turned on.

2. Select VEC GAIN from the Calibration menu, select CAL, and then select

TEST ON.

3. Adjust the

Y and B buttons so that the vector dots land in the center of the

red and cyan graticule target boxes. See Figure 5--1.

4. Adjust the

A and " buttons so that the vector dots land in the center of the

yellow and blue graticule target boxes. See Figure 5--1.

5. Select CAL MENU, and then select SAVE.

6. Select X5 PHASE from the Calibration menu, and then select CAL.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 179 180

Pas de commentaire

Monitor Audio Vector Manuel de service Page 93