Monitor Audio Vector Manuel de service télécharger pdf (Page 132)

Remove and Replace

6-32

WFM90D and WFM91D Service Manual

Replace. To replace the battery power connector:

1. Solder the battery power connector wires to the battery contacts. See

Figure 6--16.

2. Install the bottom cover. Refer to Bottom Cover on page 6--31.

Remove. To remove the battery contacts:

1. Remove the bottom cover. Refer to Bottom Cover on page 6--31.

2. To remove one of the battery contacts that has the battery power connector

soldered to it, unsolder the battery connector wire before you remove the

battery contact.

3. Pry the battery contact past the retaining lip on the bottom cover. See

Figure 6--15.

Alignment ridge

Retaining lip

Battery contacts

Figure 6- 15: Battery contact installation alignment

4. Push the battery contact through the slot on the bottom cover.

Battery Contacts

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 179 180

Pas de commentaire

Monitor Audio Vector Manuel de service Page 132