Monitor Audio Bronze BR2 Manuel d'instructions télécharger pdf (Page 12)

Connecting your Bronze BR-FX

The Bronze BR-FX’s are supplied as right hand and left hand units and both can

be configured to either bi-pole or di-pole. The factory setting is bi-pole as

illustrated in fig. 1 below.

In bi-pole mode, all speaker units (mid/bass unit and tweeters) are in phase.

This feature is for when the BR-FX is set up as a rear/surround speaker in a

typical 5.1 channel system. In di-pole mode, one of the HF units (tweeter) is out

of phase with the other tweeter and mid/bass unit. It is best to implement this

configuration when using the BR-FX as part of a 7.1 channel system, with the

BR-FX’s taking up positions on the sidewalls.

Please note that the BR-FX’s are left and right handed specific. This

is not an issue when used in bi-pole mode as a rear surround

speaker. It is essential that they are positioned correctly if used in

a 7.1 channel system.

Bi-Pole Mode

. 1

Di-Pole Mode

. 2

Before changing your BR-FX’s from bi-pole mode to di-pole mode, please ensure

that the speaker wires are disconnected from your loudspeakers. This helps to

protect your amplifier.

To change from bi-pole, to di-pole mode, the toggle switch on the crossover

panel needs to be moved from its factory set position (fig. 1) to the di-pole

position (fig. 2).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

Pas de commentaire

Monitor Audio Bronze BR2 Manuel d'instructions Page 12